Scissor-type aerial working platform operation demonstration

Aerial working platform equipment is equipped with safety protection devices and protective measures, but it can only work if it is correctly operated, maintained and used. Therefore, the safety control points of scissor-type aerial working platform should be kept in mind

1. The body of the scissor-type aerial working platform should be labeled with the following contents: the rising speed limit of the lifting platform, the rated load capacity, the maximum lifting height, the name of the manufacturer and the date of production, etc.

2. The operator of the scissor-type aerial working platform must participate in fall protection and training on the use of the lift truck before starting to operate the equipment.

3. The operator of the scissor-type aerial working platform must wear a full-body safety belt.

4. The lift truck will fasten the safety belt to the platform, basket or manufacturer-made fastening point during the lifting process. When the scissor-type aerial working platform lifted to the working height, the safety belt is no longer hanging in the scissor-type aerial working platform, should be hung to other structure reliable hanging points

5. Scissor-type aerial working platform working area shall be maintained with warning tape, set up warning signs, and set up full-time guardian.

6. When the scissor-type aerial working platform is in the rising starting position, the operator cannot leave.

7. installed scissor-type aerial working platform before use by the on-site safety engineer acceptance, and hang the permitted use of the plate before being put into use

8. The user of the scissor-type aerial working platform must operate in accordance with the operating procedures of the lift truck.

9. Every day before use must be checked, and fill in the checklist.

10. The working area of the scissor-type aerial working platform must be on the open level ground, and it is not allowed to run on the uneven ground.

11. The legs of the scissor-type aerial working platform must be fully opened and firmly supported.